Standby Settings; Standby Bootaction; Standby Control; Standby Delay - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

Standby settings

Standby BootAction

Define the camera position after a restart of the video conferencing device.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: RestoreCameraPosition
Value space: None/DefaultCameraPosition/RestoreCameraPosition
None: No action.
RestoreCameraPosition: When the video conferencing device restarts, the camera
returns to the position that it had before the restart.
DefaultCameraPosition: When the video conferencing device restarts, the camera
moves to the factory default position.

Standby Control

Define whether the device should go into standby mode or not.
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: The device will not enter standby mode.
On: The device will enter standby mode when the Standby Delay has timed out.

Standby Delay

Define how long (in minutes) the device shall be in idle mode before it goes into standby
mode. Requires the Standby Control to be enabled.
Requires user role: ADMIN, INTEGRATOR
Default value: 10
Value space: Integer (1..480)
Set the standby delay (minutes).
D15330.18 SX10 Administrator Guide CE9.12, APRIL 2020.
Configuration Peripherals Maintenance

Standby StandbyAction

Define the camera position when going into standby mode.
Requires user role: ADMIN, INTEGRATOR
Default value: PrivacyPosition
Value space: None/PrivacyPosition
None: No action.
PrivacyPosition: When the video conferencing device enters standby, the camera turns
to a sideways position for privacy.

Standby WakeupAction

Define the camera position when leaving standby mode.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: RestoreCameraPosition
Value space: None/RestoreCameraPosition/DefaultCameraPosition
None: No action.
RestoreCameraPosition: When the video conferencing device leaves standby, the
camera returns to the position that it had before entering standby.
DefaultCameraPosition: When the video conferencing device leaves standby, the camera
moves to the factory default position.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
163
Administrator Guide
Device settings Device settings Appendices