Cisco Webex Room Panorama Administrator's Manual page 37

Cisco Webex Room Panorama and Room 70 Panorama

Introduction
Set up Intelligent Proximity for content sharing
Enable Proximity services
1. Sign in to the web interface and navigate to
Configuration.
2. Go to Proximity > Mode. Check that Proximity is On (default),
so that the video conferencing device sends ultrasound
pairing messages.
Enable the services you want to allow. Only Wireless share
from a desktop client is enabled by default.
In order to fully utilise the Proximity functionality, we
recommend that you enable all services.
Place calls and control the video conferencing device:
• Go to Proximity > Services > CallControl
Enabled.
View shared content on a mobile device:
• Go to Proximity > Services > ContentShare > ToClients
and choose Enabled.
Wireless share from a desktop client:
• Go to Proximity > Services > ContentShare > FromClients
and choose Enabled.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Configuration Peripherals
The Proximity indicator
Setup > You can see the Proximity indicator on the screen as long
as at least one Proximity client is paired with the device.
The indicator doesn't disappear immediately when the last
client unpairs. It may take a few minutes.
and choose
Maintenance
(page 4 of 5)
37
Administrator Guide
Device settings
About Proximity
The Proximity feature is switched On by
default.
When Proximity is switched On, the video
conferencing device transmits ultrasound
pairing messages.
The ultrasound pairing messages are
received by nearby devices with Proximity
clients, and triggers the authentication
and authorization of the device.
Cisco recommends - for the best user
experience - that Proximity always is
switched On.
In order to get full access to Proximity,
the Proximity services (Proximity >
Services > ...) must be Enabled as well.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
Appendices