Networkservices Wifi Allowed; Networkservices Wifi Enabled; Networkservices Xmlapi Mode - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama

Introduction

NetworkServices Wifi Allowed

Devices that have a built-in Wi-Fi adapter, can connect to the network either via Ethernet
or Wi-Fi. Both Ethernet and Wi-Fi are allowed by default, and the user can choose which
one to use from the user interface. With this setting, the administrator can disable Wi-Fi
configuration, so that it cannot be set up from the user interface.
The devices support the following standards: IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE
802.11n, and IEEE 802.11ac. The device supports the following security protocols: WPA-
PSK (AES), WPA2-PSK (AES), EAP-TLS, EAP-TTLS, EAP-FAST, PEAP, EAP-MSCHAPv2,
EAP-GTC, and open networks (not secured).
If the PID (Product ID), found on the rating label at the rear of the device, contains the letters
NR (No Radio) the device does not support Wi-Fi.
Requires user role: ADMIN, USER
Default value: True
Value space: False/True
False: Wi-Fi cannot be used. You must connect to the network via Ethernet.
True: Both Ethernet and Wi-Fi are allowed.

NetworkServices Wifi Enabled

Provided that the device is allowed to connect to the network via Wi-Fi (see the
NetworkServices WIFI Allowed setting), you can use this setting to enable and disable Wi-
Fi.
You cannot use Ethernet and Wi-Fi at the same time. If you try to configure Wi-Fi while an
Ethernet cable is connected, you must unplug the Ethernet cable to proceed. If you connect
an Ethernet cable while connected to Wi-Fi, Ethernet will take precedence. If you unplug the
Ethernet cable, the device will automatically connect to the last connected Wi-Fi network, if
available.
Requires user role: ADMIN, USER
Default value: True
Value space: False/True
False: Wi-Fi is disabled.
True: Wi-Fi is enabled.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance

NetworkServices XMLAPI Mode

Enable or disable the device's XML API. For security reasons this may be disabled. Disabling
the XML API will limit the remote manageability with for example TMS, which no longer will
be able to connect to the device.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The XML API is disabled.
On: The XML API is enabled.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
132
Administrator Guide
Device settings Device settings Appendices