Networkservices Settings; Networkservices Cdp Mode; Networkservices H323 Mode; Networkservices Http Mode - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama

Introduction

NetworkServices settings

NetworkServices CDP Mode

Enable or disable the CDP (Cisco Discovery Protocol) daemon. Enabling CDP will make the
device report certain statistics and device identifiers to a CDP-enabled switch. If CDP is
disabled, the Network VLAN Voice Mode: Auto setting will not work.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The CDP daemon is disabled.
On: The CDP daemon is enabled.

NetworkServices H323 Mode

Define whether the device should be able to place and receive H.323 calls or not.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: Disable the possibility to place and receive H.323 calls.
On: Enable the possibility to place and receive H.323 calls.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance

NetworkServices HTTP Mode

Define whether or not to allow access to the device using the HTTP or HTTPS (HTTP
Secure) protocols. Note that the device's web interface use HTTP or HTTPS. If this setting
is switched Off, you cannot use the web interface.
For additional security (encryption and decryption of requests and pages that are returned
by the web server), allow only HTTPS.
Note: The default value is HTTP+HTTPS for devices that have been upgraded to CE9.4 (or
later) from an earlier software version, provided that the device has not been factory reset
after the upgrade.
Requires user role: ADMIN
Default value: HTTPS (changed from HTTP+HTTPS to HTTPS in CE9.4)
Value space: Off/HTTP+HTTPS/HTTPS
Off: Access to the device not allowed via HTTP or HTTPS.
HTTP+HTTPS: Access to the device allowed via both HTTP and HTTPS.
HTTPS: Access to the device allowed via HTTPS, but not via HTTP.

NetworkServices HTTP Proxy LoginName

This is the username part of the credentials for authentication towards the HTTP proxy.
Requires that the NetworkServices HTTP Proxy Mode is set to Manual.
Requires user role: ADMIN, USER
Default value: ""
Value space: String (0, 80)
The authentication login name.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
126
Administrator Guide
Device settings Device settings Appendices