Audio Output Line [N] Mode; Audio Soundsandalerts Ringtone; Audio Soundsandalerts Ringvolume; Audio Ultrasound Maxvolume - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama

Introduction

Audio Output Line [n] Mode

n: 1..6
Define the mode for the audio line output.
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: Disable the audio line output.
On: Enable the audio line output.

Audio SoundsAndAlerts RingTone

Define which ringtone to use for incoming calls.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: Sunrise
Value space: Sunrise/Mischief/Ripples/Reflections/Vibes/Delight/Evolve/Playful/Ascent/
Calculation/Mellow/Ringer
Select a ringtone from the list.

Audio SoundsAndAlerts RingVolume

Define the ring volume for incoming calls.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: 50
Value space: Integer (0..100)
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 =
Off.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance

Audio Ultrasound Mode

This setting applies to the Intelligent Proximity feature. Keep the setting at its default value.
Requires user role: ADMIN, INTEGRATOR
Default value: Dynamic
Value space: Dynamic/Static
Dynamic: The device adjusts the ultrasound volume dynamically. The volume may vary
up to the maximum level as defined in the Audio Ultrasound Volume MaxVolume setting.
Static: Use only if advised by Cisco.

Audio Ultrasound MaxVolume

This setting applies to the Intelligent Proximity feature. Set the maximum volume of the
ultrasound pairing messages.
The Audio Ultrasound MaxVolume and Proximity Mode settings only affect ultrasound
pairing messages. See the RoomAnalytics PeoplePresenceDetector and Standby
WakeupOnMotionDetection settings for information about the use of ultrasound in presence
and motion detection.
Requires user role: ADMIN, INTEGRATOR
Default value: 70
Value space: Integer (0..70)
Select a value in the specified range. If set to 0, ultrasound pairing messages are not
emitted.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
95
Administrator Guide
Device settings Device settings Appendices