Cisco Webex Room Panorama Administrator's Manual page 56

Cisco Webex Room Panorama and Room 70 Panorama

Introduction
Test the loudspeaker connections
Room Panorama
It is crucial for the audio experience that the device's
loudspeakers are correctly connected to the codec. Therefore
a loudspeaker test is included in the Room Panorama setup
assistant. This is described in the Getting Started guide for
the product.
You can also start the test manually from the Touch controller.
When you perform the loudspeaker test, a sound plays from
each loudspeaker in sequence.
1. Tap Settings > Issues and diagnostics > Manual speaker
check > Play Sound to start the test.
2. Tap Next to listen to the next loudspeaker, or
go back and listen to the previous loudspeaker again.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Peripherals
(page 2 of 2)
Previous to
While running the test the graphics on the screens
show a number close to the position of each
loudspeaker. The number close to the loudspeaker
that is supposed to play is marked with blue color.
• S1-S12: The loudspeakers above the screens
(behind the speaker grille)
• SB1-SB4: The subwoofers below the screens
(behind the cosmetic panels)
Maintenance
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
56
Administrator Guide
Device settings Appendices
If the loudspeakers and subwoofers are connected
correctly, you will hear that the sound is played from
the speaker in the position that is marked with blue.
If the loudspeakers play out of order, or a loudspeaker
doesn't play at all, you must check the cabling.
Read the Getting Started guide to find how to fix the
problem.