Provisioning Password; Provisioning Tlsverify; Provisioning Webexedge - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama

Introduction

Provisioning Password

This is the password part of the credentials used to authenticate the device with the
provisioning server. This setting must be used when required by the provisioning server.
Requires user role: ADMIN, USER
Default value: ""
Value space: String (0, 64)
A valid password.

Provisioning TlsVerify

This setting applies when a video conferencing device connects to a provisioning server via
HTTPS.
Before establishing a connection between the device and the HTTPS server, the device
checks if the certificate of the server is signed by a trusted Certificate Authority (CA). The
CA certificate must be included in the CA list on the device, either pre-installed or manually
uploaded using the web interface or API.
In general, the minimum TLS (Transport Layer Security) version for the HTTPS connection
is 1.1. There are two exceptions to this rule: 1) For compatibility reasons, the minimum TLS
version is 1.0 for devices that are registered to CUCM. 2) Devices registered to the Webex
cloud service always use version 1.2.
Note: The value is set to Off for a device that has been upgraded to CE9.9 (or later) from
CE9.8 or earlier software versions, provided that the device has not been factory reset after
the upgrade, and that the old NetworkServices HTTPS VerifyServerCertificate setting was
not explicitly set to On.
The certificate check is always performed, regardless of this setting, if the device is
provisioned from the Cisco Webex cloud service or from CUCM via Expressway (also
known as MRA or Edge).
Requires user role: ADMIN, USER
Default value: On
Value space: Off/On
Off: The device doesn't check the certificate of the HTTPS server.
On: The device checks if the certificate of the HTTPS server can be trusted. If not, the
connection between the device and the server is not established.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance

Provisioning WebexEdge

Define if the device is linked to Webex Edge for Devices, which gives access to select
Webex cloud services.
The setting applies only to devices that are registered to an on-premises service.
Requires user role: ADMIN, USER
Default value: Off
Value space: Off/On
Off: The device is not linked to Webex Edge for Devices.
On: The device is linked to Webex Edge for Devices.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
139
Administrator Guide
Device settings Device settings Appendices