Change The Persistency Mode - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama

Introduction

Change the persistency mode

Sign in to the web interface and navigate to
Non-persistent Mode.
Check the persistency status
The active radio buttons show the current persistency status of
the device.
Alternatively, you can navigate to Setup >
the Security category to see the Persistency
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Configuration Peripherals
Security >
Change the persistency settings
All persistency settings are set to Persistent by default. You only
have to change these settings if you want to make them Non-
persistent.
Status, and then open
status.
1. Click the radio buttons to set the persistency for
configurations, call history, internal logging, local phonebook
(local directory and favorites) and IP connectivity (DHCP)
information.
2. Click
The device restarts automatically. After the restart, the
behavior changes according to the new persistency settings.
Maintenance
Save and restart....
Logs, configurations, and other data that was stored
before you switched to Non-persistent mode, are NOT
cleared or deleted.
33
Administrator Guide
Device settings
Persistency mode
Configurations, call history, internal
logs, local phonebook (local directory
and favorites list), and IP connectivity
information are stored by default.
Because all persistency settings are set
to Persistent, a device restart does not
delete this information.
Generally, we recommend you NOT to
change the persistency settings. Only
change to Non-persistent mode if
you have to prevent users from being
able to see or traceback to any logged
information from the previous session
In Non-persistent mode, the following
information is lost or cleared each time
the device restarts:
• Device configuration changes
• Information about placed and
reveived calls (call history)
• Internal log files
• Changes to the local contacts or
favorites list
• All IP related information (DHCP) from
the last session
Information that was stored before
changing to Non-persistent
mode is not automatically cleared
or deleted. You must factory
reset the device to delete such
information.
There is more information about
performing a factory reset in
the ► Factory reset the video
conferencing device
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
Appendices
chapter.