Table of Contents
Advertisement
19
Neutral Lockout Limit Switch
NEUTRAL LOCKOUT LIMIT SWITCH
See General Warnings on page 1-2.
TESTING THE NEUTRAL LOCKOUT LIMIT SWITCH
See Test Procedure 10 – Neutral Lockout Limit Switch – Pedal-Start Vehicles Only on page 18-24.
NEUTRAL LOCKOUT LIMIT SWITCH REMOVAL
1.
Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL position.
Chock the wheels.
2.
Disconnect battery and spark plug wire(s).
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
3.
Disconnect the 3-wire connector from the neutral lockout limit switch (1) located on the transaxle.
4.
Remove two nuts (3) and washers (4) from the neutral lockout limit switch (1) and slide the limit switch off of
the screws.
NEUTRAL LOCKOUT LIMIT SWITCH INSTALLATION
1.
Install the limit switch (1) with washers (4) and nuts (3) and tighten to 5 in·lb (0.6 N·m). Move the Forward/Reverse
handle to make sure the switch actuates. See following CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are overtightened, limit switches could be damaged.
2.
Connect the 3-wire connector to the neutral lockout limit switch lead.
3.
Connect battery and spark plug wire(s).
See Connecting the Battery- Gasoline Vehicles on page 1-3.
4.
Test drive the vehicle in both forward and reverse for proper operation.
Page 19-20
2019 Precedent Villager 2 Maintenance and Service Manual
GASOLINE VEHICLE - ELECTRICAL
COMPONENTS
Advertisement
Table of Contents
Troubleshooting
