Section 5. Liquid Crystal Display (Lcd); Lcd Position & Direction; Lcd Lift Mode - ECD 100-194 EN81 Manual

Section 5. Liquid Cr ystal Display (LCD)
LCD Info, Modes, Status, buttons and navigation, Fault Log
LCD contrast is set via "Contrast" POT located to the upper left of LCD
LCD Position & Direction
02u NOR RUP ][
ECD Aust. V-6.05

LCD Lift Mode

02u NOR RUP ][
ECD Aust. V-6.05
List of Lift Modes;
 CFS
Lift on Car Fire Service
 COR Lift performing a CORrection run due to loss of position
 DDO Door Disable Open. Toggle switch provided on board
 EP
Lift on Emergency Power
 EQK EarthQuaKe detected. See EQK input
 HCB Hall Call Bypass
 HFS
Lift on Hall Fire Service
 HR
Lift on Hospital / Hall Recall
 IND
Lift on INDependent service
 INS
Lift on INSpection
 LRN LeaRNing floor operation in progress
 NOR Lift on NORmal operation
 NPT
No Pulse Time out. Fatal error. See Section 6, counting method 01, NPT
 OIL
Hydraulic OIL overheat. See OIL input
 OVL Lift OVerLoad sensor triggered. See OVL input
 PIT
Lift on PIT inspection
 PRK
Lift on Park
 UIM
UnIntended Movement. Non-commanded movement of the lift. See UIM input
 ZON Lift ZONed/zoning to floor
The lift position is shown in the top left of the LCD display, followed by the
current demand direction.
The above example shows the lift on the 2
The lift mode is shown in the top left centre of the LCD display.
The above example shows the lift on Normal
49
Section
nd floor with an up direction