Remove/Reassemble The Protective Cover - ABB GWT C9 Product Manual

5.3.1 Remove/reassemble the protective cover

General
This section describes how to remove or replace the protective cover on the welding
gun.
Required equipment
Qty
1
Removing the protective cover
xx2200000328
1
2
3
Product manual - GWT C9
3HAA010198-001 Revision: A
Equipment
Standard toolkit
Action
Read the introduction section before performing any service work, see
on page 75.
Make sure that all safety aspects are considered before performing any repair work.
If the welding gun is attached to a robot, move the robot so the welding gun is posi-
tioned in a good working high.
© Copyright 2022 ABB. All rights reserved.
5.3.1 Remove/reassemble the protective cover
Product (example)
See Standard toolkit on page
5 Repair
120.
Introduction
Continues on next page
79