Table of Contents
Advertisement
12
13
14
15
16
17
Product manual - GWT C9
3HAA010198-001 Revision: A
Action
Reassemble the M16 screw (pos. 7),
connecting the piston rod and piston rod
coupling (pos. 8). Use thread locking fluid
- Loctite 243 and tighten the screw with
tightening torque 100 Nm.
Assemble the washers (pos. 1), the insu-
lation washers (pos. 3) and the insulation
sleeves (pos. 4) onto the screws (pos. 1).
Place the insulation plate (pos. 6) and the
electrode adapter (pos. 5) in alignment
to the piston rod coupling (pos. 8).
Reassemble the screws (pos. 1) incl.
washers and sleeves. Tighten the screws
with a maximum torque of 9.8 Nm.
Reconnect the LeanID connectors.
When parts are reassembled, reassemble
the protective cover.
© Copyright 2022 ABB. All rights reserved.
5.6 Replacement of the actuator
Illustration
xx2200000339
xx2200000338
See
Remove/reassemble the protective
cover on page
79.
5 Repair
Continued
93
Advertisement
Table of Contents
