Ricoh 4800WD Operating Instructions Manual page 358

Monitoring and Configuring the Machine
Message
SMTPC: failed to connect smtp server.
3
SMTPC: username or password wasn't cor-
rect. [response code] (information)
Snmp over ip is ready.
SNMPD: account is unavailable:
Same account name be used.
SNMPD: account is unavailable:
The authentication password is not set up.
SNMPD: account is unavailable:
encryption is impossible.
SNMPD: trap account is unavailable.
snmpd start.
WINS name registration: No response to serv-
er<WINS server address>
WINS wrong scopeID=<ScopeID>
Note
❒ For details about "syslog" command, see p.55 "syslog".
66
Problem and solutions
Connection to the SMTP server failed. This
could be because:
• No connection to the network has been es-
tablished.
• The network configuration is incorrect, so
there is no response from the SMTP server.
• The specified SMTP server name is incor-
rect.
• An incorrect SMTP server is specified.
• The specified SMTP server IP address
could not be found in the DNS server.
• A server other than the SMTP server has
been specified.
• The specified SMTP server port number is
incorrect.
Connection to the SMTP server failed. This
could be because:
• The specified SMTP user name is incorrect.
• The specified SMTP password is incorrect.
Check the SMTP user name and password.
Communication over TCP/IP with snmp is
available.
User account is disabled. This could be be-
cause it use the same account name as the ad-
ministrator account.
User account is disabled. This could be be-
cause the authentication password is not set,
and only the encryption account is set.
Encryption is not possible and account is disa-
bled. This could be because:
• Security option is not installed.
• Encryption password has not been speci-
fied.
v3Trap cannot be sent. This could be because
the Trap destination account is different from
the account specified by the printer.
The snmpd service has started.
There was no response from the WINS server.
Check the correct WINS server address is en-
tered. Alternatively, check the WINS server is
functioning properly.
An invalid scope ID was used. Use a valid
scope ID.