Ricoh 4800WD Operating Instructions Manual page 302

Connecting and Setting Up
Confirming the Connection
A A A A
Make sure the LED of the IEEE 802.11b
interface unit is lit.
❖ ❖ ❖ ❖ When using in infrastructure mode
2
1.
If [LAN Type] on the [Interface Set-
tings]/[Network] screen is not set to
[IEEE 802.11b], it does not light, even
if the main power is on.
2.
If it is connected properly to the
network, the LED is green when in
infrastructure mode. If the LED is
blinking, the machine is searching
for devices.
❖ ❖ ❖ ❖ When using in ad hoc mode/802.11
ad hoc mode
1.
If the IEEE 802.11b interface unit
is working, it is lit in orange.
2.
If it is connected properly to the
network, the LED is green when in
ad hoc mode or 802.11 ad hoc mode.
If the LED is blinking, the machine
is searching for devices. The LED
will light after a few seconds.
10
Checking the machine's radio wave status
When using in infrastructure mode,
you can check the machine's radio
wave status using the control panel.
Note
❒ To check the radio wave status,
press [IEEE 802.11b] under [LAN
Type] on the [Network] screen.
A A A A
Press the { { { { User Tools/Counter/Inquiry} } } }
key.
1
B B B B
2 Press [System Settings].
C C C C
Press [Interface Settings].
ZZZ024S
D D D D
Press [IEEE 802.11b].
E E E E
Press [Wireless LAN Signal].
The machine's radio wave status
appears.
F F F F
After checking radio wave status,
press [Exit].
G G G G
Press the { { { { User Tools/Counter/Inquiry} } } }
key to return to the User Tools /
Counter / Inquiry menu.
1
2
ZZZ024S