Ricoh 4800WD Operating Instructions Manual page 346

Monitoring and Configuring the Machine
❖ ❖ ❖ ❖ Access configuration
msh> snmp "number" {ip/addr
| ipx} "address"
• You can configure a host ad-
dress according to the protocol
used.
• The network interface board ac-
cepts requests only from hosts
that have addresses with access
types of "read-only" or "read-
3
write". Enter "0" to have network
interface board accept requests
from any host without requiring
a specific type of access.
• Enter a host address to deliver
"trap" access type information to.
• To specify TCP/IP, enter "ip"
followed by a space, and then
the IP address.
• To specify IPX/SPX, enter "ipx"
followed by a space, the IPX ad-
dress followed by a decimal,
and then the MAC address of
the network interface board.
❖ ❖ ❖ ❖ sysLocation configuration
msh> snmp location
❖ ❖ ❖ ❖ Deleting sysLocation
msh> snmp clear location
❖ ❖ ❖ ❖ sysContact setting
msh> snmp contact
❖ ❖ ❖ ❖ Deleting sysContact
msh> snmp clear contact
❖ ❖ ❖ ❖ SNMP V1V2 function configuration
msh> snmp v1v2 {on | off}
• Specify "on" to enable, and "off"
to disable.
❖ ❖ ❖ ❖ SNMP v3 function configuration
msh> snmp v3 {on | off}
• Specify "on" to enable, and "off"
to disable.
54
❖ ❖ ❖ ❖ SNMP TRAP configuration
msh> snmp trap {v1 | v2 |
v3} {on | off}
• Specify "on" to enable, and "off"
to disable.
❖ ❖ ❖ ❖ Remote Configuration Authorization
configuration
msh> snmp remote {on |
off}
• Specify "on" to enable, and "off"
to disable.
❖ ❖ ❖ ❖ SNMP v3 TRAP configuration display
msh> snmp v3trap
msh> snmp v3trap {1- 5}
• If a number from 1-5 is entered,
settings are displayed for that
number only.
❖ ❖ ❖ ❖ Configuring a sending address for
SNMP v3 TRAP
msh> snmp v3trap {1-5}
{ip| ipx} "address"
❖ ❖ ❖ ❖ Configuring a sending protocol for
SNMP v3 TRAP
msh> snmp v3trap {1-5} ac-
tive {ip/addr | ipx} {on |
off}
❖ ❖ ❖ ❖ Configuring a user account for SNMP
v3 TRAP
msh> snmp v3trap {1-5} ac-
count "account_name"
• Enter an account name using up
to 32 alphanumeric characters.
❖ ❖ ❖ ❖ Deleting an SNMP v3 TRAP user ac-
count
msh> snmp v3trap {1-5}
clear account