Ricoh 4800WD Operating Instructions Manual page 32

Getting Started
{ { { { Scanner Stop} } } } key
10.
Use if originals are feeding in slanted,
or to cancel scanning while an original
is feeding in. You can also use this to
release the paper edge hold function.
1
11.
Original table
Place originals here scanning side up.
12.
Original guide
Set to the width of your originals.
13.
Imaging unit release lever
Use this lever to open the imaging
unit when clearing paper jams inside
or cleaning the machine.
❖ ❖ ❖ ❖ Rear
1.
Document roller
Rolls and stacks long length or rolled
originals here.
2.
Rear original exit (straight)
Holds originals ejected at the back of
the machine. See "Original Output
Locations", Copy Reference.
20
Important
❒ Do not leave the imaging unit
open more than 10 minutes,
otherwise copy quality may de-
teriorate.
Note
❒ While holding down the imaging
unit, pull the release lever to open
it.
14.
Paper Bypass
Use to feed paper in manually. Load
paper print side up. See "Copying
from the Paper Bypass", Copy Refer-
ence.
15.
Paper bypass's paper guide
Set to the width of the paper for by-
pass copying.
3.
Fusing unit cover
Protects the fusing unit.
4.
Ventilation holes
Prevent overheating. Do not obstruct
them by placing anything near or lean-
ing objects against them. If the ma-
chine overheats, a failure might occur.
AHD018S