Ldap Server Settings; Before Using This Function; Program/Change/Delete Ldap Server - Ricoh 4800WD Operating Instructions Manual

LDAP Server Settings

Program the LDAP server to find up
e-mail destinations in the LDAP serv-
er Address Book directly. This func-
tion is possible when sending scan
files by e-mail using the scanner func-
tion.

Before using this function

To start an LDAP search, make sure
that the items listed below are set. For
other items, check your environment
and make any necessary changes.
• Server Name
• Search Base
• Port No.
• Search Conditions
• Authentication method selection
Note
❒ For authentication method, se-
lect from [High Security], [On], or
[Off].
• User Name/Password
The settings above differ depend-
ing on server environment. Check
your environment and make any
necessary changes.
Note
❒ To use the LDAP server in Admin-
istrator Tools, select [On] under
[LDAP Server].
❒ This function supports LDAP Ver-
sion 2.0 and 3.0. Ver 2.0 does not
support High Security authentica-
tion.
Program/Change/Delete LDAP
Server
To enter Program/Change/Delete
LDAP Server
A A A A
Press the { { { { User Tools/Counter/Inquiry} } } }
key.
B B B B
Press [System Settings].
C C C C
Press [Administrator Tools], and then
press [T T T T Next] twice.
D D D D
Press [Program / Change / Delete LDAP
Server].
To program/change the LDAP server
A A A A
Select the LDAP server you want
to program or change.
When programming the server, se-
lect [*Not Programmed].
B B B B
Set each item as necessary.
LDAP Server Settings
33
2