Ricoh 4800WD Operating Instructions Manual page 318

Connecting and Setting Up
Limitation
❒ Enter [Scope ID] using up to 31
alphanumeric characters.
Note
❒ Default: Off
❖ ❖ ❖ ❖ IP over 1394
2
When you use the IP over 1394
function of the IEEE 1394 interface
to connect the machine to the net-
work, or you print from computer
with the IP over 1394 driver, you
must specify [Active]for [IP over
1394].
• Active
• Inactive
Note
❒ Default: Active
IEEE 802.11b
Preparation
You must install the optional IEEE
802.11b interface unit into the ma-
chine.
Note
❒ Be sure to make all settings simul-
taneously.
❖ ❖ ❖ ❖ Communication Mode
Specifies the communication mode
of the wireless LAN.
• 802.11 Ad hoc
• Ad hoc
• Infrastructure
Note
❒ Default: 802.11 Ad hoc
❖ ❖ ❖ ❖ SSID Setting
Specifies SSID to distinguish the
access point in infrastructure
mode or 802.11 ad hoc mode.
26
Limitation
❒ The characters that can be used
are ASCII 0x20-0x7e (32 bytes).
Note
❒ Default: blank (ASSID)
❒ If blank is specified in 802.11b
ad hoc mode or ad hoc mode,
"ASSID" appears.
❖ ❖ ❖ ❖ Channel
Specifies a channel when you se-
lect 802.11b ad hoc mode or ad hoc
mode.
Note
❒ Default: 11
❒ The following channels are
available:
• Metric version: 1-13
• Inch version: 1-11
❖ ❖ ❖ ❖ WEP (Encryption) Setting
Specifies the encryption of the
IEEE 802.11b (wireless LAN). If
this is set to [Active], you must en-
ter the WEP key.
• VWEP
• Active
• Inactive
• VEncryption
10 alphanumeric characters
must be entered for 64 bit, 26
characters for 128 bit.
Note
❒ Default: Inactive
❖ ❖ ❖ ❖ Wireless LAN Signal
Shows the radio wave conditions
of the access point connected in in-
frastructure mode.
Note
❒ Radio wave status is displayed
when you press [Wireless LAN
Signal].