Show; Smb - Ricoh 4800WD Operating Instructions Manual

Monitoring and Configuring the Machine
msh> set ftp
msh> set rsh
msh> set web
msh> set snmp
msh> set ssl
msh> set nrs
msh> set rfu
msh> set http
❖ ❖ ❖ ❖ Configuration
3
• Enter "up"to enable protocol,
and enter "down" to disable
protocol.
You can set the protocol to "active"
or "inactive".
msh> set tcpip {up | down}
• If you disable TCP/IP, you can-
not use remote access after log-
ging off. If you did this by
mistake, you can use the control
panel to enable remote access
via TCP/IP.
• Disabling TCP/IP also disables
ip1394, ftp, rsh, web, snmp, ssl,
and http.
msh> set smb {up | down}
msh> set ip1394 {up | down}
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
msh> set ftp {up | down}
msh> set rsh {up | down}
msh> set web {up | down}
msh> set snmp {up | down}
msh> set ssl {up | down}
• If Secured Sockets Layer (SSL,
an encryption protocol) func-
tion is not available for the ma-
c h i n e , y o u c a n n o t u s e t h e
function by enabling it.
msh> set nrs {up | down}
msh> set rfu {up | down}
52
msh> set http {up | down}

show

Use the "show" command to display
network interface board configura-
tion settings.
❖ ❖ ❖ ❖ View settings
msh> show
• If "-p" is added, you can view
settings one by one.
Reference
For details about the information
displayed, see p.60 "Configuring
the Network Interface Board".

smb

Use the "smb" command to configure
or delete the computer or workgroup
name for SMB.
❖ ❖ ❖ ❖ Computer Name settings
msh> smb comp
• Set computer name using up to
15 characters. Names beginning
with "RNP" or "rnp" cannot be
entered.
❖ ❖ ❖ ❖ Working Group Name settings
msh> smb group
• Set workgroup name using up
to 15 characters
❖ ❖ ❖ ❖ Comment settings
msh> smb comment
• Set comment using up to 31
characters
❖ ❖ ❖ ❖ Deleting Computer Name
msh> smb clear comp
❖ ❖ ❖ ❖ Deleting Group Name
msh> smb clear group