Ricoh 4800WD Operating Instructions Manual page 317

❖ ❖ ❖ ❖ Permit SSL / TLS Communication
Set the encrypted communication
of SSL/TLS.
• Ciphertext Only
• Ciphertext Priority
• Ciphertext / Clear Text
Note
❒ Default: Ciphertext Priority
❒ If you set to [Ciphertext Only], you
need to install the server authen-
tification for the machine.
❖ ❖ ❖ ❖ Host Name
Specify the host name.
❖ ❖ ❖ ❖ Machine Name
Specify the machine name.
IEEE 1394
Preparation
You must install the optional IEEE
1394 interface board in the machine.
❖ ❖ ❖ ❖ IP Address
When you connect the machine to
a network using the IEEE 1394 in-
terface, you must configure the IP
address and subnet mask.
• Auto-Obtain (DHCP)
• Specify
When you select [Specify], enter
the [IP Address] and [Sub-net
Mask] as "xxx.xxx.xxx.xxx"("x"
indicates a number).
• IP Address: 011.022.033.044
• Sub-net Mask:
000.000.000.000
Note
❒ Default: Auto-Obtain (DHCP)
Setting Up the Machine on a Network
❒ If you use the interface for Eth-
ernet and IEEE 1394 (IP over
1394) at the same time, settings
must be made carefully. See
p.67 "Using DHCP"
❒ When you use the IEEE 1394 in-
terface on a network, you can-
not use the Ethernet interface in
the same domain. To use both
interfaces in the same domain,
set different values for the [Sub-
net Mask].
❒ The physical address (EUI-64)
also appears.
❖ ❖ ❖ ❖ DDNS Configuration
You can specify the DDNS settings.
• Active
• Inactive
Note
❒ Default: Inactive
❖ ❖ ❖ ❖ Host Name
Specify the host name.
❖ ❖ ❖ ❖ Domain Name
Make settings for the domain name.
• Auto-Obtain (DHCP)
• Specify
• Domain Name
❖ ❖ ❖ ❖ WINS Configuration
You can specify the WINS server
settings.
• On
If [On] is selected, specify the
[V V V V WINS Server] IP address as
"xxx.xxx.xxx.xxx" ("xxx" indi-
cates a number).
If DHCP is in use, specify the
[Scope ID].
• Primary WINS Server
• Secondary WINS Server
• Scope ID
• Off
2
25