H Position (Pc Signal Input Only); Position (Pc Signal Input Only); H Size (Pc Signal Input Only); Aspect - Christie APS Series User Manual

4. Adjust to the least interference state.

H position (PC signal input only)

If the relative position of both projector and the screen are set up right, move the image horizontal position
when the position of the projected image on the screen is deviated.
1. Select to select H position menu.
2. Select OK.
3. Select to adjust image H position.
Adjustment range: -5 to 5
V position (PC signal input only)
If the relative position of both projector and the screen are set up right, move the image vertical position, if
the position of the projected image on the screen is deviated.
1. Select to select V position menu.
2. Select OK.
3. Select to adjust image V position.
Adjustment range: -5 to +5

H size (PC signal input only)

Adjust and reduce the interference caused by patterns of the projected vertical stripes. The following
projected patterns may cause a circular pattern (noise). Adjust the amount of interference to the minimum.
Users can point the clock to adjust images.
1. Select to select H size menu.
2. Select OK.
3. Select to adjust H size level .
Adjustment range: -15 to 15

Aspect

Adjust the image to fit the screen size, while keeping aspect of input signals unchanged.
• When the projector is in digital focusing state, the aspect ratio is displayed as DZOOM IN.
1. Select to select the Aspect menu.
2. Select OK.
3. Select to select the required item.
• Normal—Uses the maximum size to project while keeping the aspect of input signals
unchanged.
APS Series User Manual
020-002086-01 Rev. 1 (05-2023)
Copyright 2023 Christie Digital Systems USA, Inc. All rights reserved.
©
If printed, please recycle this document after use.
Menu items
34