Christie APS Series User Manual page 54

Preparing the network
Follow these steps to prepare the network.
• Christie recommends using a Category 5 or higher LAN cable.
1. Gather the required equipment: projector, computer, and network cable.
2. Make the connection:
Connect the projector to a router or switch in the LAN with normal or jumper network cable. If a
normal network cable failed to connect successfully, use a jumper cable.
3. Turn on the computer.
The LAN port on computer and projector are flashing after power on the projector.
Operating the projector
Follow these steps to operate the projector.
1. Power on the projector.
2. Acquire the IP address, with DHCP set to On and Automatically obtain the IP address.
You can set DHCP to Off and set up the IP address manually if familiar with networking.
3. Enter the network setup menu.
APS Series User Manual
020-002086-01 Rev. 1 (05-2023)
Copyright 2023 Christie Digital Systems USA, Inc. All rights reserved.
©
If printed, please recycle this document after use.
Menu items
54