Wake On Lan Operation - Christie APS Series User Manual

Wake on LAN operation

The Wake on LAN function enables you to wake up the projector on LAN.
1. Connect the projector to the computer with a network cable.
2. Set the network configuration on the computer.
3. Change the adapter setttings in the Control Panel Network and Sharing Center.
4. Set the IP address.
a. Right-click Ethernet.
b. Set the IP to be in the same network segment as the IP on the projector (DHCP is set to Off in
the projector's network settings).
5. Open the Wake On LAN_2.11.11.0 tool.
6. Select File > New Host > Display Properties > Name tab and customize a name.
7. On the Wake Up tab in the MAC address field, enter the MAC address of the (no colon).
8. Enter the computer name.
9. Select the IPV4 information as the one set on the computer.
10. Return to the Display Properties tab and select OK.
11. On the projector, set the standby mode to Network standby.
12. Shut down the projector.
13. Power on the projector.
14. Once the projector enters into Standby mode, right-click on the group and select Wake up.
APS Series User Manual
020-002086-01 Rev. 1 (05-2023)
Copyright 2023 Christie Digital Systems USA, Inc. All rights reserved.
©
If printed, please recycle this document after use.
76