Connecting To Ports - Christie APS Series User Manual

6 ENTER
7 POWER indicator
8 STATUS indicator
9 LIGHT indicator

Connecting to ports

The following is the introduction of some functions of the terminal board of this projector device.
Notice. If not avoided, the following could result in property damage.
• Both ends of the nineth PIN of the VGA cable must be connected first and not connected to
the GND PIN.
• The nineth PIN of the source device is required to be VCC.
• Use the cables with straight plugs (not the L-shaped ones) as the input ports of the
projector are recessed.
LWU605ST-APS
1
10
APS Series User Manual
020-002086-01 Rev. 1 (05-2023)
Copyright 2023 Christie Digital Systems USA, Inc. All rights reserved.
©
If printed, please recycle this document after use.
• Enters the on-screen display (OSD) menu
• Selects options in the on-screen display (OSD) menu .
Displays the power status of the projector.
Lights up/flashes when a button is selected with the CONTROL PANEL LOCK
enabled or when an error occurs in the projector.
Displays the state of light source, used time of the light source.
2 3 4 5
Installation and setup
6 7
9 8
15