Configuring The Projector For The 3D Source; Connecting Devices To The 3D Sync Ports - Christie Crimson Series Installation And Setup Manual

9. View the displayed test pattern. If you can see both Ls and Rs with both eyes, increase the
dark interval until the Ls are only visible to the left eye and the Rs are only visible to the right
eye.
10. Optionally, to adjust the 3D Sync delay, select 3D Sync Delay.
This adjusts the timing of the sync pulse in relation to the dark time transition on the DMDs.
Use the default value of 0 as a starting point.
11. Adjust the slider or enter the delay value.
12. To confirm your selection, select Enter.

Configuring the projector for the 3D source

Configure the projector for the 3D source.
1. Select the appropriate port configuration and then set the inputs for your video source (on
page 39).
2. To select the correct EDID timing, select MENU > Configuration > Input Settings > EDID
Timing.
3. Select the required EDID timing and select Enter.
4. Connect all the required cables between the 3D source and the projector.
5. Configure your 3D source.

Connecting devices to the 3D sync ports

The 3D Sync Input and Output ports located on the IMXB faceplate provide a convenient method for
interfacing the projector to the 3D stereo projection system.
Connect the 3D Sync Input to the video source for synchronization of the left eye/right eye
frames of Direct input 3D or for frame doubled content.
The 3D Sync Input is not required for Dual-Input 3D. The 3D Sync Output is available for
control of an IR Emitter for active glasses or a polarization device for passive glasses.
Crimson Installation and Setup Guide–Crimson HD25, Crimson WU25, Crimson HD31, Crimson WU31, Mirage HD25, Mirage WU25
020-102647-07 Rev. 1 (12-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
3D setup for Mirage projectors
44