Configuring The Projector For The 3D Source; Connecting Devices To The 3D Sync Ports - Christie Mirage 4K40-RGB Installation And Setup Manual

10. Optionally, to adjust the 3D Sync delay, select 3D Sync Delay.
This adjusts the timing of the sync pulse in relation to the dark time transition on the DMDs.
Use the default value of 0 as a starting point.
11. Adjust the slider or enter the delay value.
12. To confirm your selection, select Enter.

Configuring the projector for the 3D source

Configure the projector for the 3D source.
1. Select the appropriate port configuration and then set the inputs for your video source (on
page 44).
2. To select the correct EDID timing, select MENU > Configuration > Input Settings > EDID
Timing.
3. Select the required EDID timing and select Enter.
4. Connect all the required cables between the 3D source and the projector.
5. Configure your 3D source.

Connecting devices to the 3D sync ports

Connect the 3D Sync Input to the video source for synchronization of the left eye/right eye
frames of Direct input 3D or for frame doubled content.
The 3D Sync Input is not required for Dual-Input 3D. The 3D Sync Output is available for
control of an IR Emitter for active glasses or a polarization device for passive glasses.
Mirage 4K40-RGB Installation and Setup Guide
020-103014-03 Rev. 1 (08-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
3D setup for Mirage projectors
49