Replacing The Slide-In Module; Removing The Slide-In Module - Thermo Scientific Vanquish VH-P10 Operating Manual

7.16 Replacing the Slide-In Module

7.16.1 Removing the Slide-In Module

Tools required
Preparations
Follow these steps
Vanquish Pumps (VH-P10) Operating Manual
CAUTION—Heavy Load, Bulky Device
The pump is too heavy or bulky for one person alone to handle safely. To
avoid personal injury or damage to the pump, observe the following
guidelines:
•
Physical handling of the pump, including lifting or moving, requires a
team effort of two persons.
•
A team effort is in particular required when lifting the pump into the
system stack or when removing it.
Screwdriver, Torx T20
Prepare the pump for transport. See the Transporting or Shipping the
Pump section in this operating manual.
1. Loosen the four captive screws on the front left and front right of
the pump.
Figure 70: Captive screws on the slide-in module
7 • Maintenance and Service
Page 181