Preparation; Separating Hydraulic Cylinder - Kubota BX24 Workshop Manual

BX24, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM

[2] PREPARATION

• Before proceding this section, disassembling the loader assembling and backhoe . (Refer to section 8 and
9.)

(1) Separating Hydraulic Cylinder

Battery
CAUTION
• When disconnecting the battery cables, disconnect the
negative cable from the battery first. When connecting,
connect the positive cable to the battery first.
1. Remove the under panel (1).
2. Disconnect the negative cable (2) from the battery.
(1) Under Panel
(2) Battery
Roll-Over Protective Structures (ROPS) and Seat
1. Disconnect the lead wires from the hazard lights (2), (4) and turn
signal lights (3), (5).
2. Remove the ROPS mounting nuts, and remove the ROPS (1).
3. Disconnect the seat switch connectors.
4. Remove the snap pin (7) and remove the seat (6).
(When reassembling)
Tightening torque ROPS mounting nut
(1) ROPS
(2) Hazard Light LH
(3) Turn Signal Light LH
(4) Hazard Light RH
Speed Control Pedal and Step
1. Remove the valve covers (3).
2. Remove the speed control pedals (1) and step (2).
(1) Speed Control Pedal
(2) Step
5-S8
HYDRAULIC SYSTEM
(3) Negative Cable
W1026961
124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 ft-lbs
(5) Turn Signal Light RH
(6) Seat
(7) Snap Pin
W1027220
(3) Valve Cover
W1014726
KiSC issued 08, 2019 A