Kubota BX24 Workshop Manual page 171

BX24, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
HST Front Cover
1. Remove the internal cir-clip (4).
2. Remove the HST front cover.
3. Remove the HST front cover (1) not to damage the oil seal (5).
4. Remove the center section (6).
(When reassembling)
1. Do not damage the oil seal (5).
2. Tighten the HST mounting bolts and the nut to the factory
specifications.
HST front cover mounting
Tightening torque
bolt (M8)
HST front cover mounting
Tightening torque
nut (M8)
(1) HST Front Cover
(2) Transaxle Assembly
(3) Bolt
Center Section and Valve Plates
1. Remove the valve plates (2) (4).
(When reassembling)
1. Check the direction of the groove (4).
2. Install the valve plates (2) (3) to the anchor pins (5) securely.
3. Install the groove (6) of the valve plate (pump plate) to the engine
side.
(1) Center Section
(2) Valve Plate (Pump Shaft)
(3) Valve Plate (Motor Shaft)
2-S24
TRANSAXLE
18.0 to 21.0 N·m
1.8 to 2.1 kgf·m
13.3 to 15.5 ft-lbs
18.0 to 21.0 N·m
1.8 to 2.1 kgf·m
13.3 to 15.5 ft-lbs
(4) Internal Cir-clip
(5) Oil Seal
(6) Center Section
W1086612
(4) Groove
(5) Anchor Pin
(6) Groove
W1086956
KiSC issued 08, 2019 A