Kubota BX24 Workshop Manual page 413

BX24, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
Dipperstick Cylinder, Boom, Boom Cylinder and Hoses
1. Disconnect the hydraulic hoses and remove the dipperstick
cylinder (4).
2. Remove the pins (1), (3) and remove the boom cylinder (2).
3. Remove the pin (6) and remove the boom (5).
4. Remove the hydraulic hoses from the control valve.
(When reassembling)
• Lock the locking nuts to setting bolts at position where the
mounting bolt may still be rotated.
• Connect the hydraulic hoses at their original positions and be
sure to connect the hose angle as indicated table below.
Port
T, P
A6, B6
P.B.
A1, A2, B1, B2
(Reference)
• Color of type
Port
A1, B1
A2, B2
A3, B3
A4, B4
A5, B5
NOTE

• P port is short hose without sleeve.
• T port is long hose with sleeve.
(1) Pin (30  142 mm)
(2) Boom Cylinder
(3) Pin (30  169 mm)
(4) Dipperstick Cylinder
(5) Boom
(6) Pin (1.18  7.96 in.)
(7) T Port (Tank)
(8) A1 Port (Rod Side of Bucket
Cylinder)
(9) A2 Port (Rod Side of Dipperstick
Cylinder)
(10) A3 Port (Bottom Side of Stabilizer
Cylinder RH)
(11) A4 Port (Bottom Side of Stabilizer
Cylinder LH)
(12) A5 Port (Bottom Side of Boom
Cylinder)
(13) A6 Port (Rod Side of Swing
Cylinder)
(14) P.B. Port (Power Beyond)
(15) B6 Port (Bottom Side of Swing
Cylinder)
(16) B5 Port (Rod Side of Boom
Cylinder)
(17) B4 Port (Rod Side of Stabilizer
Cylinder LH)
(18) B3 Port (Rod Side of Stabilizer
Cylinder RH)
(19) B2 Port (Bottom Side of Dipperstick
Cylinder)
(20) B4 Port (Bottom Side of Bucket
Cylinder)
(21) P Port (Pump)
9-S13
BACKHOE
Angle of Bent Tube
L 1.57 rad (L 90 )
R 1.83 rad (R 105 )
R 2.09 rad (R 120 )
R 0.17 rad (R 10 )
Color
Red
Orange
Green
White
Yellow
a : Bottom Side of Bucket Cylinder
b : Bottom Side of Dipperstick
Cylinder
c : Rod Side of Boom Cylinder
d : Rod Side of Bucket Cylinder
e : Rod Side of Dipperstick Cylinder
f : Bottom Side of Boom Cylinder
L : Installation Angle
R : Installation Angle
KiSC issued 08, 2019 A