Kubota BX24 Workshop Manual page 157

BX24, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
Adjustment of HST Neutral Position
1. Start the engine.
2. Keep the engine at the maximum revolution.
3. Shift the range shift lever (1) to "Hi" position (B).
4. Loosen the locking screw (5).

NOTE
• When adjusting the HST neutral position, loosen the locking
screw approximately 2 turns counterclockwise not to drop
the nut inside.
• Make sure 4WD lever is 2WD before making adjustment.
(Forward to Neutral Position)
5. Depress the speed control pedal (3) to "Forward" speed position,
and release the foot from the speed control pedal (3). Check that
the rear axle (or the wheel) stops rotating.
If the rear axle (or the wheel) does not stop rotating, move the
position of the locking screw (5) to the machine front side to stop
rotating.
(Reverse to Neutral Position)
6. Depress the speed control pedal (3) to "Reverse" speed position,
and release the foot from the speed control pedal (3). Check the
rear axle (or the wheel) stops rotating. If the rear axle (or the
wheel) does not stop rotating, adjust the locking screw (5) to stop
rotating.
7. After adjusting the neutral position, tighten the lock screw (5)
securely.
(1) Range Gear Shift Lever
(2) Front Wheel Drive
(3) Speed Control Pedal
(4) Neutral Adjust Lever
(5) Locking Screw
(6) Screw Driver
2-S10
TRANSAXLE
(A) 4WD "OFF" Position
(B) "Hi" Position
(C) FORWARD
(D) REVERSE
W1012819
KiSC issued 08, 2019 A