Kubota BX24 Workshop Manual page 181

BX24, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
Rear Axle Case (RH)
1. Remove the rear axle case (RH) mounting bolts.
2. Remove the rear axle case (RH) (1) as an assembly from the
transaxle case.

NOTE
• Since the adjusting shims are installed behind the 37T spiral
bevel gear, check the shims.
3. Remove the 37T spiral bevel gear (2).
4. Remove the 10T final gear shaft (3).
5. Remove the 66T final gear with the differential lock shift fork.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to the joint
surface of transaxle case to the rear axle (RH) case.
Rear axle case (RH)
Tightening torque
mounting bolt (M8)
(1) Rear Axle Case (RH)
(2) 37T Spiral Bevel Gear
2-S34
TRANSAXLE
18.0 to 21.0 N·m
1.8 to 2.1 kgf·m
13.3 to 15.5 ft-lbs
(3) 10T Final Gear Shaft (Brake Shaft)
(4) 66T Final Gear
W1091120
KiSC issued 08, 2019 A