Kubota BX24 Workshop Manual page 95

BX24, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
Oil Pan and Oil Strainer
1. Remove the oil pan mounting screws (1).
2. Remove the oil pan (2) by lightly tapping the rim of the pan with
a wooden hammer.
3. Remove the oil strainer (3).
(When reassembling)
• After cleaning the oil strainer, check to see that the filter mesh in
clean, and install it.
• Visually check the O-ring (4), apply engine oil, and install it.
• Securely fit the O-ring to the oil strainer.
• To avoid uneven tightening, tighten oil pan mounting screws in
diagonal order form the center.
• Using the hole (6) numbered "3", install the oil strainer by
mounting screw

IMPORTANT
• Scrape off the old adhesive completely. Wipe the sealing
surface clean using waste cloth soaked with gasoline. Now
apply new adhesive 3 to 5 mm (0.12 to 0.20 in.) thick all over
the contact surface. Apply the adhesive also on the center
of the flange as well as on the inner wall of each bolt hole.
• Cut the nozzle of the "liquid gasket" (Three Bond 1207D or
equivalent) container at its second notch. Apply "liquid
gasket" about 3 to 5 mm (0.12 to 0.20 in.) thick.
Within 20 minutes after the application of fluid sealant,
reassemble the components.
minutes, and pour oil in the crankcase.
(1) Oil Pan Mounting Screw
(2) Oil Pan
(3) Oil Strainer
1-S29
ENGINE
Wait then for about 30
(4) O-ring
(5) Hole Numbered "2"
(6) Hole Numbered "3"
W10236610
KiSC issued 08, 2019 A