Kubota BX24 Workshop Manual page 100

BX24, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
Idle Gear
1. Remove the external snap ring (3), the collar (2) and the idle gear
(1).
2. Remove the idle gear shaft mounting screws (4).
3. Remove the idle gear shaft (5).
(When reassembling)
• Apply engine oil to the idle gear shaft mounting screw (4). And
tighten them.
• Install the idle gear, aligning the mark (6) on the gears referring
to the photo.
Idle gear shaft mounting
Tightening torque
screw
(1) Idle Gear
(2) Idle Gear Collar
(3) External Snap Ring
Camshaft
1. Remove the camshaft mounting screws (1) and draw out the
camshaft with gear (2) on it.
(When reassembling)
• When install the camshaft, apply engine oil to the camshaft
journals.
• Apply engine oil to the camshaft mounting screws. And tighten
them.
(1) Camshaft Mounting Screw
1-S34
ENGINE
9.8 to 11.3 N·m
1.00 to 1.15 kgf·m
7.2 to 8.3 ft-lbs
(4) Idle Gear Shaft Mounting Screw
(5) Idle Gear Shaft
(6) Alignment Mark
W1030437
(2) Camshaft Gear
W1030808
KiSC issued 08, 2019 A