Kubota BX24 Workshop Manual page 210

BX24, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
Bevel Pinion Shaft and Differential Gear Assembly
1. Take out the differential yoke shaft (4), (7).
2. Remove the oil seal (11).
3. Remove the internal snap ring (1).
4. Pull out the bevel pinion shaft (3).
5. Take out the differential gear assembly (5), from right side of front
axle case (6).
6. Remove the stake of lock nut (10), and then remove the lock nut
(10).
7. Remove the taper roller bearing (9).
(When reassembling)
• Apply gear oil to the taper roller bearings (9) and install them
correctly, noting their direction.
• Replace the lock nut (10) and oil seal (11) with new ones.
• After tighten the lock nut (10) to the specified torque, stake it
firmly.
• Install the adjusting collars (2), (8) to their original position.
(1) Internal Snap Ring
(2) Adjusting Collar
(3) Bevel Pinion Shaft
(4) Differential Yoke Shaft LH
(5) Differential Gear Assembly
(6) Front Axle Case
Differential Gear
1. Remove the bevel gear (5) with bearing (6) and bearing (9) by
puller.
2. Remove the spring pin (10).
3. Remove the differential pinion shaft (8).
4. Remove the differential pinions (2), differential side gears (4) and
shims (1), (3).

NOTE
• Arrange the parts to know their original position.
(When reassembling)
• Apply molybdenum disulfide (Three Bond 1901 or equivalent) to
the inner circumferential surface of the differential side gears,
differential pinions and shims.
(1) Shim
(2) Differential Pinion
(3) Shim
(4) Differential Side Gear
(5) Bevel Gear
3-S11
FRONT AXLE
(7) Differential Yoke Shaft RH
(8) Adjusting Collar
(9) Taper Roller Bearing
(10) Lock Nut
(11) Oil Seal
(12) Collar
W12345678
(6) Bearing
(7) Differential Gear Case
(8) Differential Pinion Shaft
(9) Ball Bearing
(10) Spring Pin
W1028857
KiSC issued 08, 2019 A