Operation - MAGSTIM 3190-00 Operating Manual

Figure 4.2: Locating key on the coil connector (left) and the receptor on the stimulator coil output socket (right)
3. Care must be taken to attach the coil connector to the stimulator correctly (see Figure 4.).
Note: Failure to do so can cause damage to the connector pins and in severe cases, internal
damage to the coil and the stimulator.
4. Following an initialisation sequence, the stimulator will recognise the coil and the system will be
ready to use.
4.3

Operation

4.3.1
Use of Remote Control Coils with Magstim 200²
1. When the coil is connected to the stimulator and ready to use, remove the coil from the coil holder
of the right hand side of the stimulator*. The coil will show the output power of the system on the
multi-function display*.
2. Use the up and down buttons* on the remote control coil to adjust the power to the desired level.
3. Use one of the multi-function buttons* to charge the system by engaging the button and holding it
for two seconds. The coil's ready indicator* will illuminate when the system has charged to the
correct level and is ready to deliver the stimulus.
4. Position the coil over the desired target; Figure 6.3 (90mm) and 6.4 (D70) shows the peak
stimulation points of each coil.
5. Engage both multi-function buttons* at the same time to trigger the stimulator and deliver the
stimulus.
A clicking noise should be heard from both the remote control coil and the stimulator.
© The Magstim Company Limited
Coil locating key
Figure 4.3: Diagram showing correct and incorrect ways to connect the coil to the stimulator
10
Magstim 2nd Generation Coils
Operating Manual
Coil output
socket receptor
MOP04-EN-03