Table of Contents
Advertisement
im Vertrieb von
Installation, cont'd
Routing A/V cables through the MLM-WB+ side panel
Installing Equipment
This section explains how to install and cable equipment in the 2U rack enclosure
and the 4U rack enclosure.
Installing and cabling equipment in the 2U rack enclosure
The 2U rack enclosure accommodates 1U and 2U faceplates or any Extron
VersaTools
(part #60-190-20).
1.
2.
3.
4.
www.camboard.de
2-12
MLM-WB+ • Installation
CAMBOARD Electronics
®
product mounted using the VersaTools Rack Shelf
If applicable, set up any A/V devices (e.g., AAPs, MLC 206, etc.) to be
installed. Refer to the documentation that shipped with each device.
Connect power, A/V, and control cables to the rear connectors of the devices
attached to the faceplates or rack shelves. For detailed cabling instructions,
refer to the documentation shipped with each device.
Trim back any exposed cable shields (braids or foil) or insulate them with heat
shrink.
To prevent short circuits, the outer foil shield can be cut back to the point
where the cable exits a cable clamp. Both braided and foil shields should be
connected to an equipment ground at the other end of the cable.
Carefully place the faceplates or rack shelves into the 2U rack opening. Using
the appropriate number of rack screws, attach the faceplate or shelf to the rack.
Do not tighten the screws completely until you have tested the installation and
made any necessary adjustments to the cabling or switch settings.
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de
Advertisement
Table of Contents
