im Vertrieb von
Installation, cont'd
3.
From the underside of the table, bolt the clamshell to the
enclosure with two bolts of optimum length (included)
(see figure 2-1 on page 2-3).
4.
Experiment with AAP cable positioning between the
enclosure and the clamshell to ensure that the cables do
not rub against the edges of the AAP cable access hole and
to ensure that the cable pull does not restrict the
movement of the top panel. Figure 2-7 shows the cables
routed to the side, which proved effective in tests at Extron.
Secure the AAP cables at the circled location.
Figure 2-7 — HSA 822M AAP cable routing in the
clamshell
5.
Use tie wraps to secure the AAP cables to the tie-down
holes in the clamshell shown on figure 2-7.
www.camboard.de
2-10
HSA 822M • Installation
CAMBOARD Electronics
Cabling the Enclosure
Bottom panel connectors and other features
Tel. 07131 911201
Fax 07131 911203
2
4
8
6
1
5
1
3
4
8
7
Figure 2-8 — HSA 822M underside features
RJ-45 connectors — See Cabling the RJ-45 connectors on page 2-12.
1
AC power connector — Plug a standard IEC power cord into
2
this connector to connect the enclosure to the appropriate power
source:
• 125 VAC, 60 Hz, 5 A (US domestic version)
• 220-240 V, 50/60 Hz, 5 A (international versions)
Control and status captive screw connector — See Cabling the
3
control and status captive screw connector on page 2-13.
Cable access holes*
4
Spare AAP/RJ-45 panel screws*
5
Power supply assembly*
6
Control board assembly*
7
Cable tie-downs*
8
Items marked with an asterisk (*) have limited
accessibility once the clamshell is installed.
ce-info@camboard.de
HSA 822M • Installation
2-11