Memory Riser Assembly; Figure 9-8 Torque-Indicator Driver Storage Location - Sun Microsystems Ultra 80 Service Manual

c. Align the audio module assembly bracket tab with the chassis back panel
cutout.
d. At the two upper corners of the module, push the module straight down into
the slot until the module is fully seated.
e. Using a No. 2 Phillips screwdriver, replace the screw securing the audio
module assembly to the system chassis.
2. Detach the antistatic wrist strap.
3. Connect any external audio cables to the audio card.
4. Replace the access panel and power on the system.
See Section 6.3 "Replacing the Access Panel/Powering On the System" on page 6-6.
9.6

Memory Riser Assembly

Note – The torque-indicator driver, part number 340-6091, must be used to loosen
and tighten the torque-limiting screws on the memory riser assembly. The
torque-indicator driver is kept in the green torque tool carrier that is stored in the
center of the hard drive cage.
FIGURE 9-8
Torque-Indicator Driver Storage Location
Chapter -19