Replacing The Scsi Assembly; Figure 7-13 Removing And Replacing The Scsi Assembly (Sheet 2 0F 2) - Sun Microsystems Ultra 80 Service Manual

FIGURE 7-13
7.9.2

Replacing the SCSI Assembly

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Replace the SCSI assembly as follows (
a. Join the SCSI assembly to the hard drive cage.
b. Using a No. 2 Phillips screwdriver, replace the four screws securing the SCSI
assembly to the hard drive cage.
2. Replace the hard drive cage as follows (
a. Position the hard drive cage into the chassis and connect the hard drive cage to
the chassis cutouts.
b. Using a No. 2 Phillips screwdriver, proceed as follows:
-26 Sun Ultra 80 Service Manual • March 2000
Removing and Replacing the SCSI Assembly (Sheet 2 0f 2)
Screw (4)
Hard drive cage
SCSI assembly
):
FIGURE 7-13
):
FIGURE 7-12