Chassis Foot; Removing A Chassis Foot - Sun Microsystems Ultra 80 Service Manual

i. Replace the two screws into the chassis bottom that secure the hard drive
cage to the chassis.
ii. Tighten the two captive screws (located on the left side of the hard drive
cage).
3. Connect the diskette drive cable assembly to the motherboard and the diskette
drive.
4. Connect the SCSI cable assemblies to the motherboard and the CD-ROM drive.
5. Connect the power connector to the SCSI assembly.
6. Replace the hard drive(s).
See Section 8.1.2 "Replacing a Hard Drive" on page 8-2.
7. Replace the fans and fan bracket.
See Section 7.7.2 "Replacing a Fan Assembly" on page 7-20.
8. Replace the air guide.
See Section 7.6.2 "Replacing the Air Guide" on page 7-18.
9. Detach the antistatic wrist strap.
10. Replace the access panel and power on the system.
See Section 6.3 "Replacing the Access Panel/Powering On the System" on page 6-6.
7.10

Chassis Foot

Use the following procedure to remove and replace a chassis foot.
7.10.1

Removing a Chassis Foot

Remove a chassis foot as follows (
Remove a chassis foot by using a flat-tipped tool to pry the foot from the chassis
(
FIGURE 7-14
FIGURE 7-14
).
):
Chapter -27