Replacing The Air Guide; Figure 7-9 Removing And Replacing The Air Guide - Sun Microsystems Ultra 80 Service Manual

FIGURE 7-9
7.6.2

Replacing the Air Guide

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Replace the air guide as follows (
a. Position the air guide into the chassis.
b. Placing fingers in the slots at the air guide top, gently push the air guide down
and towards the chassis frame until the air guide seats.
2. Detach the antistatic wrist strap.
3. Replace the access panel and power on the system.
See Section 6.3 "Replacing the Access Panel/Powering On the System" on page 6-6.
-18 Sun Ultra 80 Service Manual • March 2000
Air guide
Removing and Replacing the Air Guide
Slot (2)
):
FIGURE 7-9