Table of Contents
Advertisement
Chapter 4 – Operation
In This Chapter
4.1 Powering Up/Powering Down the ControlWave I/O Expansion Rack
Figure 4-1. Power Switches on PSSM Setting the Operating Mode (Run/Remote/Local Switch)
4.2 Communicating with the ControlWave I/O Expansion Rack
4.2.1 Default Comm Port Settings
Port
PCB
COM1
CPU
COM2
CPU
Revised Aug-2015
This chapter provides general operational details for using the
ControlWave I/O expansion rack.
4.1
Powering Up/Powering Down the ControlWave I/O Expansion Rack4-1
4.2
Communicating with the ControlWave I/O Expansion Rack ........... 4-1
4.2.1
Default Comm Port Settings ................................................. 4-1
4.2.2
Changing Port Settings ........................................................ 4-2
Open the bezel door on the PSSM and position the power switch (or
switches if you have dual supplies) to the OFF (down) position to turn
the ControlWave I/O rack OFF or to the ON (up) position to turn it ON.
ON position (up) to turn ON the power supply
OFF position (down) to turn OFF the power supply
You communicate to the ControlWave I/O rack by connecting a cable
between a port on your PC workstation and one of the ControlWave I/O
rack ports. See Section 2.4 for more information on communications.
The port at the PC workstation must match the configuration of the
ControlWave I/O rack port.
As delivered from the factory, ControlWave communication ports have
default settings. Table 4-1 details these defaults.
Table 4-1. Default Comm Port Settings (by PCB)
Default Configuration
Ships from factory at RS-232; 115.2 Kbps using BSAP. Once the default
switch is OFF, a factory default of IP Point-to-Point protocol (PPP) at
115,200 applies with an IP address of 1.1.1.1 and a mask of
255.255.255.255.
RS-232; 9600 baud, 8 bits, no parity, 1 stop bit, RTU message type
Operation
ControlWave I/O Expansion Rack Instruction Manual
4-1
Advertisement
Table of Contents
Troubleshooting
