Emerson ControlWave Instruction Manual page 80

ControlWave I/O Expansion Rack Instruction Manual
Jumper Purpose
W1 Configures UDI1
W2 through Configures UDI 2 through UDI6
W6
Wiring the Module Figure 3-27 shows field wiring assignments for the locally terminated
3-32
Table 3-13. Jumper Assignments: UDI Module
UDI module. It also includes examples for relay contact and open
collector applications. Figure 3-28 shows field wiring assignments for
the remotely terminated UDI module.
Figure 3-25. UDI (Debounce Enabled) Wiring Diagram
Figure 3-26. UDI (Debounce Disabled) Wiring Diagram
Description
Pins 1-2 installed = Enable Debounce (Factory default). A
change of state on both the SET and RST (reset) field
inputs is required to accumulate counts.
Pins 2-3 installed = Disable Debounce. A change of state
on the SET field input is required to accumulate counts.
Pins 1-2 installed = Enable Debounce (Factory default). A
change of state on both the SET and RST (reset) field
inputs is required to accumulate counts.
Pins 2-3 installed = Disable Debounce. A change of state
on the SET field input is required to accumulate counts.
I/O Modules Revised Aug-2015