Emerson ControlWave Instruction Manual page 70

ControlWave I/O Expansion Rack Instruction Manual
Figure 3-18. Local AI Module Terminal Blocks Assembly Assignments
Software Configuration To use data from any ControlWave AI module in the rack you must
3-22
Figure 3-17. Externally Powered Isolated 1-5 Volt AI - Wiring Diagram
use ControlWave Designer's I/O Configurator to modify the
ControlWave project in the host controller to add an ER_AI16 board
and then configure it. See the ControlWave Designer Programmer's
Handbook (D5125) for more information. That same manual includes
an I/O Mapping section that describes, for advanced users, the I/O map
for this module.
I/O Modules Revised Aug-2015