Emerson ControlWave Instruction Manual page 104

ControlWave I/O Expansion Rack Instruction Manual
5-8
Figure 5-5. I/O Module to Be Replaced
Open the bezel door and grasp the handle. Pull the entire module
3.
out of the chassis.
Figure 5-6. Pulling the I/O Module Out of the Housing
If you plan to replace this module with a new module, but want
4.
to retain all your existing I/O wiring to the terminal blocks, you
need to disconnect the terminal block board from the rest of the
Service & Troubleshooting
Loosen the
capture
fasteners at the
top and bottom
of the module.
Revised Aug-2015