Table of Contents
Advertisement
●
Eth1, Eth2, Eth3 and Eth4 must belong to different subnetworks.
●
Eth1, Eth3 and Eth4 are Gbits interfaces.
●
Eth2 is a 100 Mbits/s interface. It is recommended to use one of the other interfaces for LAN audio
connectivity (AES67, RAVENNA, Livewire).
5.3. Enabling / disabling the hardware bypass function
IQOYA X/LINK, X/LINK-LE and X/LINK-DUAL allow for the hardware bypass of audio inputs to audio outputs in case of
power supply failure. This concerns analog inputs & outputs 1&2, and AES/3 input & output 1.
5.4. Powering up IQOYA X/LINK
It is recommended to establish all connections before powering up the device.
IQOYA X/LINK features two internal hot swappable redundant power supply units. It is recommended to connect the two
power cords. However, only one cord may be used.
IQOYA X/LINK starts as soon as it is connected to the mains.
5.5 Steps to follow to configure IQOYA X/LINK in "Program Distribution" mode of use
Set the global parameters of your IQOYA X/LINK
If IQOYA is used for encoding:
●
Adjust the parameters of the audio inputs: type (analog, AES3, AES67, RAVENNA, Livewire), and gain.
●
Declare the programs (encodings)
●
Declare the IP services to be streamed over IP (IP audio streams)
If IQOYA is used for decoding:
●
Adjust the parameters of the audio outputs: type (analog, AES3, AES67, RAVENNA, Livewire), and gain.
●
Declare the IP services to be received from the network (IP audio stream)
●
Declare the output program(s)
●
Check the status and metrics on the output programs.
If IQOYA is used for transcoding:
●
Declare the IP services to be received from the network
●
Declare the programs to be decoded from the received IP services, and assign them to internal audio buses.
IQOYA X/LINK range user manual
Enabling / disabling the hardware pass
26
Advertisement
Table of Contents
