Digigram IQOYA X/LINK Series User Manual page 102

DHCP
IPv4 address
Subnet mask
Default Gateway
Primary DNS
Secondary DNS
Possible values are as follows:
We recommend avoiding the "Auto-negotiation" mode. Select the
mode supported by the network node connected to the IQOYA
X/LINK.
Read/Write Allows enabling/disabling DHCP (Dynamic Host Configuration
Protocol). Default value is OFF (disabled).
Click on "On" to enable DHCP. This mode disables the 5 following
parameters.
Read only if DHCP DHCP Off
is On Default value is:
Read/Write if DHCP 192.168.0.100 for Eth1,
is Off 192.168.1.100 for Eth2,
192.168.2.100 for Eth3,
192.168.3.100 for Eth4
Enter the IP address of this ethernet interface.
DHCP On
Displays the IP address automatically set by DHCP.
Read only if DHCP DHCP Off
is On Enter the mask of the subnetwork this ethernet port belongs to.
Read/Write if DHCP DHCP On
is Off Displays the subnetwork mask automatically set by DHCP.
Read only if DHCP DHCP Off
is On Enter the default gateway IP address. Streams sent beyond the
Read/Write if DHCP subnets configured on LAN1 to 4 will pass through this gateway
is Off except if specific routing rules have been defined in the IP routing
page.
ethernet interfaces. If several gateways have to be used, one can
be set as default gateway, the others must be the subject of routing
rules in the IP routing page.
DHCP On
Displays the gateway IP address automatically set by DHCP.
Read only if DHCP DHCP Off
is On Enter the IP address of the primary DNS (if any).
Read/Write if DHCP DHCP On
is Off Displays the IP address of the DNS automatically set by DHCP.
Read only if DHCP DHCP Off
IQOYA X/LINK range user manual
Only one default gateway must be configured for all the
102