Digigram IQOYA X/LINK Series User Manual page 71

Parameter Type
FEC stream (Forward error Correction)
IP address Read/Write
Port Read/Write
Network interface/VLAN Read/Write
Local source port Read/Write
DSCP Read/Write
Payload type Read/Write
Click on "Save" to confirm the settings. Click on "Save & New" to confirm the settings and create a new IP service with the
same parameters.
Click on "Close" to discard the settings.
Encapsulation = None and Transport protocol = UDP
Description
Enter the destination IP address (unicast or multicast) of the FEC stream.
Enter the destination UDP port of the FEC stream.
Select the network interface or VLAN for this FEC stream.
In case the target address is unicast, select "Any" so that the Eth interface is determined automatically
according to this IP address, or select a VLAN.
In case the target IP address is multicast, select the Eth interface or the VLAN.
Local UDP port number of IQOYA SERV/LINK
Select the quality of service (QoS) class of the FEC stream.
RTP payload of the FEC stream. Value 98 is recommended.
IQOYA X/LINK range user manual
71