Table of Contents
Advertisement
DHCP
IPv4 address
Subnet mask
Default gateway
Primary DNS
Secondary DNS
8.1.1.3.2 Preferences −> Network −> VLAN
This page allows declaring VLANs on the ethernet interfaces. No VLAN is declared by default.
Multiple VLANs can be declared for each ethernet interface.
follows:
We recommended to avoid the "Auto-negotiation" mode. Select the mode supported
by the network node connected the IQOYA.
Read/Write
Allows enabling/disabling DHCP (Dynamic Host Configuration Protocol). Default
value is OFF (disabled).
Click on "On" to enable DHCP. This mode disables the following parameters.
Read if DHCP is On
DHCP Off
Write if DHCP is Off
Default value is:192.168.0.100 for Eth1, 192.168.1.100 for Eth2, 192.168.2.100 for
Eth3, 192.168.3.100 for Eth4
Enter the IP address of this ethernet interface.
DHCP On
Displays the IP address automatically set by DHCP.
Read if DHCP is On
DHCP Off
Write if DHCP is Off
Enter the mask of the subneworkt this ethernet port belongs to.
DHCP On
Displays the subnetwork mask automatically set by DHCP.
Read if DHCP is On
DHCP Off
Write if DHCP is Off
Enter the default gateway IP address. Streams sent beyond the subnets configured
on LAN1 to 4 will pass through this gateway except if specific routing rules has been
defined in the IP routing page.
several gateways has to be used, one can be set as default gateway, the others mu
be the subject of routing rules in the IP routing page.
DHCP On
Displays the default gateway IP address automatically set by DHCP.
Read if DHCP is On
DHCP Off
Write if DHCP is Off
Enter the IP address of the primary DNS (if any).
DHCP On
Displays the IP address of the DNS automatically set by DHCP.
Read if DHCP is On
DHCP Off
Write if DHCP is Off
Enter the IP address of the secondary DNS (if any).
DHCP On
Displays the IP address of the secondary DNS automatically set by DHCP (may be
empty).
IQOYA X/LINK range user manual
Only one default gateway must be configured for all the ethernet interfaces. If
48
Advertisement
Table of Contents
